Gardner-bender 1105A Operating Valve and Hose Assembly User Manual download pdf

IMPORTANT: RECEIVING INSTRUCTIONS: Visually inspect

all components for shipping damage. If any shipping damage is

found, notify carrier at once.

Shipping damage is NOT covered by warranty. The carrier is

responsible for all repair or replacement costs resulting from

damage in shipment.

Instruction

Sheet

1105A

Operating Valve

and Hose Assembly

IMPORTANT—USER SAFETY AND PROTECTION: In setting up systems to fit your operations, care must be taken to select the

proper components and design to insure appropriate integration with your operations and existing equipment and that all safety

measures have been taken to avoid the risk of personal injury and property damage from your application or system.

GARDNER BENDER CANNOT BE RESPONSIBLE FOR DAMAGE OR INJURY CAUSED BY UNSAFE USE, MAINTENANCE

OR APPLICATION OF ITS PRODUCTS. Please contact GARDNER BENDER for guidance when you are in doubt as to the

proper safety precautions to be taken in designing and setting up your particular application.

Prior to attaching the1105A hose fitting to a

2 tank valve, be certain the tank valve is

closed. CO

2 escaping under pressure will

cause injury.

INSTALLATION

The 1105A operating valve and hose assembly

consists of a 1225A operating valve and a 12

foot hose assembly. See Figure 1.

Figure 1

1105A Operating Valve and Hose Assembly

Swaged fittings on the hose assembly are

“factory installed” and are not replaceable. If

hose or fittings are damaged, discard the hose

assembly (UG12). The 1175A and 1180 coupling

can be replaced.

For hoses longer than 12 feet remove 1180

coupling and connect UG12 to existing hose and

replace 1180 coupling.

NOTE: The 1105A hose assembly is specifically

designed for use on GB Model 950 and

GB Model 1208 CO

tanks. Do not

attempt to modify the 1105A valve and

hose assembly to fit any other type of

gas or compressed air tanks such as

oxygen, acetylene, etc.

ATTACH THE 1105A OPERATING VALVE AND

HOSE ASSEMBLY to a 20 or 50 pound CO

tank. Thread the hose coupling nut “hand tight”

onto the tank valve. See Figure 2.

Figure 2

Tank and 1105A Operating Valve & Hose Assembly

1 2

Instruction 1
RPS-0093 0110 2

Summary of Contents

Page 1 - Instruction

IMPORTANT: RECEIVING INSTRUCTIONS: Visually inspectall components for shipping damage. If any shipping damage isfound, notify carrier at once.Shipping

Page 2 - RPS-0093 0110

6101 N. Baker Road, Milwaukee, WI 53209Phone: (414) 352-4160 FAX (414) 352-2377WARRANTY: GARDNER BENDER warrants itsproducts against defects in workm

Comments to this Manuals

No comments

Gardner-bender 1105A Operating Valve and Hose Assembly User Manual

Browse online or download User Manual for Equipment Gardner-bender 1105A Operating Valve and Hose Assembly. Gardner Bender 1105A Operating Valve and Hose Assembly User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Gardner-bender 1105A Operating Valve and Hose Assembly