IMPORTANT: RECEIVING INSTRUCTIONS: Visually inspect
all components for shipping damage. If any shipping damage is
found, notify carrier at once.
Shipping damage is NOT covered by warranty. The carrier is
responsible for all repair or replacement costs resulting from
damage in shipment.
Instruction
Sheet
JO21112
GUNSLINGER
™
KIT
IMPORTANT—USER SAFETY AND PROTECTION: In setting up systems to fit your operations, care must be taken to select the
proper components and design to insure appropriate integration with your operations and existing equipment and that all safety
measures have been taken to avoid the risk of personal injury and property damage from your application or system.
GB ELECTRICAL CANNOT BE RESPONSIBLE FOR DAMAGE OR INJURY CAUSED BY UNSAFE USE, MAINTENANCE OR
APPLICATION OF ITS PRODUCTS. Please contact GB ELECTRICAL for guidance when you are in doubt as to the proper safety
precautions to be taken in designing and setting up your particular application.
KIT COMPONENTS
#40 Needles (Pkg. of 5 w/Allen Wrench)
FOR USE IN ALL LARGE CONDUIT 1 1/4" THRU 6"
GUNSLINGER (Figure 1) is a rugged, positive action, compact
hand tool, especially designed and constructed for releasing a
cartridge filled with CO2 under pressure. This self-propelled
cartridge, when launched into a conduit, works its way up,
down, and around bends, laying a strong nylon line as it goes.
Suitable for runs up to 250 feet. Longer runs may be accom-
plished by shooting from both ends. Use nylon line to put JET
LINE poly rope or PL232 pull rope through conduit in minutes.
Jet Line's GUNSLINGER works well in any type conduit; metal,
fibre, plastic. Air leaks in the conduit run will not affect the per-
formance of the JO21112 GUNSLINGER.
OPERATING INSTRUCTIONS FOR GUNSLINGER
CO2 cartridges are sensitive to heat–do not expose to high
temperatures above 200° F. When firing in cold weather, warm
the cartridge in the palm of your hand for maximum travel.
Cartridges work best at 70° to 90° F.
When using Pull Line LP1703, pull gun back slightly after firing
cartridge to allow line to feed in straight without binding.
On long runs where the cartridge cannot go through in one
direction launch two cartridges from opposite ends of the run.
This allows lines to tangle while in motion, making a strong,
firm tangle-splice in the pipe. If mud or moisture are known to
exist, the cartridge will not penetrate the blockage.
YOUR GUNSLINGER CAN BE USED WITH LINE PACKAGES
OR BULK NYLON LINE OR BOTH TOGETHER. PLEASE
READ THE FOLLOWING INSTRUCTIONS BEFORE FIRING
YOUR GUNSLINGER.
USING LINE PACKAGE
Figure 7
GUNSLINGER with
Line Package
To use line package with cartridge pull several inches of line
from the center of the line package and wind around the han-
dle to serve as an anchor. Tie the loop from the twisted end of
the package to the ring on the neck of the cartridge and insert
the open end of the line package on the rod beneath the barrel,
Figure 2
#210J Entrance Adapter - 1 each
Figure 3
#J511 CO
2
Cartridge - 5 each
Figure 4
#550 Cartridge Nose Cone - 5 each
Figure 5
#LP2254 Tag-along Package - 5 each
Figure 6
#LP1703 Bulk
Nylon Line - 1 each
Figure 1
#300 Gun
(8 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals